On my Raspberry Pi 3 running Raspbian iwconifg produces the following fancy output:
`wlan0 IEEE 802.11bgn ESSID:"ssid of my network"
Mode:Managed Frequency:2.452 GHz Access Point:*************
Bit Rate=72 Mb/s Tx-Power=1484 dBm
Retry short limit:7 RTS thr:off Fragment thr:off
Power Management:on
Link Quality=36/76 Signal level=-73 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
lo no wireless extensions.
eth0 no wireless extensions`
According to the definition of dBm (see https://en.wikipedia.org/wiki/DBm) such a high tx power is not possible due to energy conservation :-).
well I have the following questions:
- how to do a setup?
- i need to set the tx-powerm right?
- What do I have to do, to see the right tx-power?
Latest comments (0)