DEV Community

Discussion on: What are your debugging tips?

Collapse
wesen profile image
Manuel Odendahl

More crazy techniques that I've used in the past, especially to figure out weird edge cases:

This is something you should do anyway, but:
put your system under immense pressure, and introduce faults into different subsystems. Every piece of software is going to break at scale in some way, might as well figure it out early. Bugs often happen in the error path / through cascading failures in the sidepath.

Embedded software

In embedded, be very careful with debuggers. They often shred the performance and behaviour of the system under test. If you can afford it and EE put in the right connectors, use a full CPU instruction trace debugger.

Use logic analyzer + scope and as many traces as possible. Know your tools inside and out (trigger settings, bus decoding, recording, etc...). Make sure the impedance of the probe doesn't mess with the signals (see next point).

Don't underestimate the power of putting your finger on communication buses / pins / power lines (provided they are low voltage). If the line starts going haywire on the scope while holding a finger somewhere, you have faulty traces or are missing proper impedance or bus termination. Many a bug is actually a badly connected bus line / missing pull ups.

Also, don't forget to check that your device is actually powered on: often, your device will get backpowered through the debugging adapter in the first place, and barely operate because of the low current (very fun).

Embedded again: use LEDs a lot, potentially even build additional LED boards that you can attach to subsystems without influencing voltage too much.

Again in embedded, use a little circuit with an amplified piezo, and put it on different communication lines or gpios. You can tick certain loops of your program, or toggle a gpio in an interrupt. Connect the piezo, which will start clicking in frequency. The human ear is very very sensitive, and you will identify any change in frequency or irregular patterns without even have to look at the device or the scope.

Use musical notes

Use MIDI events to debug your code instead of printf. For example, webmidi is very easy to use in the browser. Connect it to a synthesizer and choose notes for different events (or samples). You can now listen to your code executing, and don't have to look at the debugger / log output. You can hear if an unexpected event happens. The human brain is strongly connected to audio, chances are you'll remember the "melody" of a bug happening, which will allow you to figure out the execution path taken.

Collapse
thormeier profile image
Pascal Thormeier

Woah, that midi technique sounds amazing, honestly! Are you using that on a regular basis?

Thread Thread
wesen profile image
Manuel Odendahl

No it’s been quite a while honestly but I was thinking of bringing it back out and making a nice example!

Collapse
mmuller88 profile image
Martin Muller

Yeah agree the midi sound technique litterrly sounds super intereting!